Envoy NT9010A Przewodnik Instalacji Pobierz pdf (Strona 34)

Chapter 2: Advanced Programming

[04] - Away Arm

Arms the system in Away mode. All Stay/Away type zones will be active at the end

of the exit delay. Delay type zones will provide entry and exit delay. The Quick Arm

feature must be enabled for this key to function (Section [015], option [4]). If Quick

Arming is not enabled, the user must enter a valid access code after pressing the

function key in order to arm the system in the Away mode.

[05] - [✱]+[9] No-Entry Delay Arm

After this function key is pressed the user must enter a valid access code. The sys-

tem will arm and remove entry delay from the system when the exit delay expires

(see [*] [9] Arming Without Entry Delay on page 28).

[06] - [✱]+[4] Door Chime On/Off

Pressing the key will toggle the Door Chime feature ON or OFF. One solid beep

means the feature has been disabled, three short beeps means it has been enabled.

[07] - [✱]+[6]...[4] System Test

This function key provides the user with a simple method for testing the system

(see [*] [6] User Functions on page 27).

[08] - [✱]+[1] Bypass Mode

This function key provides the user with a simple method for entering the Bypass

Mode. If an access code is required it must be entered before bypassing can be per-

formed (see [*] [1] Zone Bypassing on page 25).

[09] - [✱]+[2] Trouble Display

This function key provides the user with a simple method for entering the Trouble

Display Mode (see [*] [2] Trouble Announcements on page 26).

[10] - [✱]+[3] Alarm Memory

This function key provides the user with a simple method for entering the Alarm

Memory Display Mode (see [*] [3] Alarm Memory on page 27).

[11] - [✱]+[5] Programming Access Codes

This function key provides the user with a simple method for programming access

codes. After this key is pressed a valid System Master or Supervisor Code will have

to be entered before the system will allow programming to be performed (see [*]

[5] Programming Access Codes on page 27).

[12] - [✱]+[6] User Functions

This function key provides the user with a simple method for programming User

Functions. After this key is pressed a valid System Master or Supervisor code must

be entered before the system will allow User Functions to be performed (see [*]

[5] Programming Access Codes on page 27).

[13] - [15] For Future Use

[16] - [✱]+[0] Quick Exit

Pressing this key will cause the system to activate the Quick Exit feature (see section

[*] [0] Quick Exit on page 29).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

Brak uwag

Envoy NT9010A Przewodnik Instalacji Strona 34