Envoy NT9010A Przewodnik Instalacji Pobierz pdf (Strona 52)

Chapter 2: Advanced Programming

NOTE: When power is applied to the system, a 6 hour downloading win-

dow will be enabled. This will allow you to perform downloading without

having to do any keypad programming.

When an event occurs that the system is programmed to communicate to the cen-

tral station, the system will disconnect from the downloading computer and report

the event. This will happen for all events except test transmissions.

If the Answering Machine/Double Call option is enabled (or during the first 6

hours after power up) the system will answer incoming calls for downloading pro-

vided the following conditions occur:

1. The system hears one or two rings, then misses a ring.

2. The system starts the Answering Machine Double Call Timer.

3. If the system hears another ring before the timer expires, it will answer on the

first ring of the second call.

4. The system will immediately go on line and begin the download process unless

the Call Back option is enabled.

5. If Call Back is enabled, the system and computer will both hang up. The system

will then call the Download Computer Telephone Number and wait for the

computer to answer. Once the computer answers, downloading will begin.

If the User Enabled DLS Window option is ON, the user can activate the down-

loading feature by entering [✱][6][Master Code][5].

✱✱Except for the first six hours after power up, the system will not answer incom-

ing calls unless the Answering Machine/Double Call option is enabled, or the

Number of Rings is programmed to be more than [0].

If the User-Initiated Call-Up option is enabled, the user can have the system ini-

tiate a call to the downloading computer by pressing [✱][6][Master Code][6].

The Download Access Code and Panel Identifier Code are for security and

proper identification. Both the system and the computer file should have the same

information programmed before attempting to download.

The time to complete a successful download can be significantly reduced with the

use of the PC-Link adaptor. This adaptor makes it possible to perform on-site

downloading.

To perform PC-LINK please do the following:

• Set up the downloading computer close to where the NT9010 is installed.

• Remove the NT9010 from the top two latches and allow the unit to sit at a 90

degree angle to the backplate. The unit may also be completely removed from

the backplate.

• Connect the PC-LINK header in the slot provided in the back of the unit.

• Ensure that the downloading computer has initiated the PC-LINK session.

To Initiate Local Downloading via PC-Link, enter [

✱] [8] [Installer’s Code] [499]

[Installer’s Code] [499]. The keypad will be busy for the duration of the PC-Link con-

nection. The status LEDs will display the current system status. For more informa-

tion on connecting the PC-Link adaptor, refer to your “PC-Link Download Kit

Instruction Sheet”.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Komentarze do niniejszej Instrukcji

Brak uwag

Envoy NT9010A Przewodnik Instalacji Strona 52

Komentarze do niniejszej Instrukcji