Envoy NT9010A Przewodnik Instalacji Pobierz pdf (Strona 56)

Chapter 2: Advanced Programming

2.3.21 Installer

Lockout

If Installer Lockout is selected a hardware default cannot be performed.

When Installer Lockout Disable is selected the system will restore all program-

ming to factory defaults if a hardware or software default is performed.

To enable or disable Installer Lockout perform the following:

1. Enter Advanced Programming.

2. To enable Installer Lockout, enter section [990]. To disable Installer Lockout,

enter section [991].

3. Enter the Installer Code.

4. Enter section [990] or [991] again.

Installer Lockout Enable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [990]

Installer Lockout Disable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section [991]

2.3.22 Walk Test The Installer Walk Test can be used to test the alarm state of each zone of the

system. Before beginning the walk test, ensure the following conditions are met:

1. The system is disarmed

2. The Keypad Blanking option is disabled (section [016]: [3])

3. The Fire Bell is Continuous option is disabled (section [014]: [8])

4. The Transmission Delay is disabled, if Transmission Delay is not required (section

[370])

NOTE: Fire Troubles are not supported in Walk Test.

To perform a Walk Test, do the following:

1. Enter Advanced Programming

2. Enter Section [901]

When any zone is violated the system will activate the Bell Output for two seconds,

log the event to the Event Buffer and communicate the alarm to the central station.

Each zone should be tested several times during the test. Check the event buffer to

ensure that all zones and FAP keys are functioning properly.

NOTE: The transmission delay timer will affect the communication of

events during walk test mode.

To stop the test, you must do the following:

1. Enter Advanced Programming

2. Enter Section [901]

Zones do not have to be restored to stop the test.

NOTE:The Alarm Memory is cleared upon entering Walk Test mode.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Brak uwag

Envoy NT9010A Przewodnik Instalacji Strona 56